Table of Contents
Advertisement
Installation area
Built under or
built in appliance
installation
42
Appliance stability is important so that the washing
machine does not wander" during the spin cycles.
The installation area must be solid and even. Soft floor
surfaces, such as carpets or surfaces with foam
backing, are not suitable.
If the washing machine is to be installed on a wood
joist ceiling:
q If possible, place the washing machine in a corner
of the room.
q Screw a water resistant wooden board (at least
30 mm thick) to the floor.
q Affix the feet of the washing machine using holding
brackets*.
If the washing machine is to be placed on a pedestal:
q Affix the feet of the washing machine using holding
brackets*.
*
Holding brackets (set) can be obtained from
a specialist store or the Customer Service (or
der no. WMZ 2200).
The appliance must be built under or built in prior to
connecting the power supply.
The appliance can be built into or under a kitchen
work surface. For this purpose, a recess width of
60 cm is required.
q The washing machine must only be installed under
a one piece worktop that is permanently attached
to the surrounding cabinets.
Caution
For safety reasons in built under installation, a metal
cover* must be assembled by a specialist in place of
the appliance cover plate.
*
The metal cover (set) can be obtained from
a specialist store or the Customer Service
(order no. WMZ 2390).
Hide quick links:
Advertisement
Table of Contents
