Installing The Saddle Post - GHOST EPAC Ghost Original Operating Instructions

GHOST EPAC
EN

13.2.2 Installing the saddle post

1. If the insertion area is free of grease:
Grease the insertion area of the saddle post.
Push the saddle with saddle post into the saddle tube of the frame until the
required saddle height is obtained. In this position the lower end of the saddle
post must be at least 10cm below the upper edge of the saddle tube.
NOTE:
Do not rely on the marking on the saddle post.
Check the correct insertion depth as follows:
Place a finger tip against the saddle post in the installed position
immediately above the clamping bolt.
150
Leave your finger in this position and pull the saddle
post out of the saddle tube.
E - H Y B R I D E A N D A S O L & A N D A S O L X
E - H Y B R I D E T E R U & T E R U FS
Original operating instructions 11/2014