Ubee DVW3201B Subscriber User Manual page 62

Using the Wireless Radio Option
Wireless Interfaces
Wireless
Country
Output Power
802.11 Band
802.11 n-Mode
802.11 N Support Required
Bandwidth
Sideband for Control Channel
(40 Mhz only)
Control Channel
58
Label
Displays the wireless name and MAC address.
Displays the wireless radio's status, Enabled or Disabled.
Defines the country where this device is used.
Sets the percent of the Output Power for the radio.
Defines the radio band as 2.4Ghz or 5 Ghz. Note: The
distance coverage for 5Ghz is less than 2.4Ghz.
Sets the wireless networking standard. Select Auto to use
802.11 n mode when possible. This mode has a significant
increase in the maximum raw OSI physical layer data rate
from 54 Mbit/s to a maximum of 600 Mbit/s with the use of
four spatial streams when at a channel width of 40 MHz.
Defines whether 802.11n support is required (on) or not (off).
On forces the gateway to 802.11n mode and clients must
support 802.11n.
Sets the bandwidth to 20Mhz or 40Mhz. For 40 Mhz, set the
sideband to lower or upper 20Mhz. 40 MHz channels double
the channel width. This allows doubling the PHY data rate
over a single 20 MHz channel.
Sets the sideband control to the lower or upper 20 MHz when
the bandwidth is set to 40Mhz.
Selects a specific channel 1-11 to deploy the wireless
network. This allows you to set the operating
frequency/channel depending on your particular region.
Channel selection can have an impact on wireless networking
performance. For more information, refer to
Wireless Channel on page 70
Ubee DVW3201B Advanced Wireless Voice Gateway Subscriber User Guide • July 2012
Description
Selecting a
Ubee Interactive