Insert the grind worm (A) into the grinder body (B). Place the knife (C) over the
square shank at the exposed end of the grind worm. Place grinding plate (D) over
the knife, matching the tabs of the plate with the notches of the grinder body. Place
ring (E) on grinder body, turning by hand until secured but not over tightened.
Note: Use wrench (F) for removal only, do not use to tighten ring.
Before attaching accessory, turn off
and unplug unit.
Loosen attachment knob (1) by turn-
ing it counterclockwise. Remove
attachment hub cover. Insert attach-
ment shaft housing (2) into attachment
hub (3) making certain that attach-
ment power shaft fits into square hub
socket. Rotate attachment back and
forth if necessary. When attachment
is in proper position, the pin on the
attachment will fit into the notch on
the hub rim. Tighten attachment knob
until attachment is completely
secured to mixer.
Rotating Blade Hazard
Always use food
Keep fingers out of
Keep away from
Failure to do so can
result in cuts or other
Cut food into small strips or pieces
and feed them into hopper. Meat
should be cut into long narrow strips.
Turn mixer to Speed 4 and feed food
into hopper using food pusher. Never
put your fingers in the hopper.
Note: Liquid may appear in hopper
when processing large amounts of high
moisture foods such as tomatoes or
grapes. To drain liquid, continue to
operate mixer. Do not process addition-
al food until liquid has drained from
hopper; damage to mixer may result.