Basic Installation
Before installing, make sure that the ignition-switch is set to OFF
and remove the terminal of the car battery to avoid short-circuiting.
1. Remove the existing receiver unit.
2. Make the necessary connections.
3. Install the installation sleeve.
4. Install the unit in to the installation sleeve.
Removing existing receiver unit
If there is already an installation sleeve for the receiver unit in the
dashboard, it must be removed.
When removing the unit from the installation sleeve
If you need to remove the unit from the installation sleeve,
proceed as follows.
1. Remove the rear supporter from the unit.
2. Remove the front panel and trim ring from the unit.
3. Insert the lever
into the hole on one side of the unit. Do the
A
same operation on the other side and pull out the unit from the
installation sleeve.
Installation
Bend the claws
according to
the thickness
of the
dashboard
A
A
11