Charging The Battery; Using The Battery Charger - Samsung Jitterbug User Manual

2. Turn the phone over. At the bottom of the
battery cover you will see an arrow.
3. Towards the top of the cover, there is a
ridge, under the speaker holes. Push down
just below this ridge and then slide down,
in the direction of the arrow. Remove the cover.
4. T o remove the battery, simply slide a ingernail in the groove at the top of the
battery, and gently pull the battery out.
The Jitterbug Rechargeable Battery must be fully charged before using
the phone for the irst time. We recommend an initial charge of up to
12 hours. Failure to do so may damage your battery. If you use your
Jitterbug without charging the battery, and it is critically low, it will turn
itself off.
14 Getting Started

Charging The Battery

Your Jitterbug can be charged with the included Battery Charger or with the
Car Charger that can be purchased by visiting
accessories.

Using The Battery Charger:

1. A Battery Charger is included in the box with your
Jitterbug.
2. Plug the large end of the Battery Charger into a standard
wall outlet (110/220 VAC).
3. Plug the smaller end into the Power Connector. You'll see
a "Charging" message on the Outside Display.
4. When the battery is fully charged, you'll see a "Charging Completed"
message on the Outside Display. Please reference Section 1, page 18 for more
information on the Outside Display.
www.greatcall.com/jitterbug/
Getting Started 15