Setting Up The Kaufman Km-25 Thermometer; Temperature Units; Temperature Variation; Exit Setup Mode - Kaufman KM-25 User Manual

1.

TEMPERATURE UNITS

Press the PROG button for 3 seconds, the screen will show: C-F.
Press '-' to choose Celsius, or '+' for Fahrenheit.
Confirm selection by pressing the PROG button.
2.
TOTAL TEMPERATURE VARIATION
T
O ADJUST THE TOTAL TEMPERATURE VARIATION OF THE THERMOMETER
The total temperature variation can be set for each measurement mode.
To do this, select the temperature measurement mode (Body, Surface or Room).
Press the PROG button for 3 seconds, the screen will show: C-F.
Press the PROG button again and TOF will be displayed on the screen.
Press '+' to increase variation by 0.1°C, '-' to reduce by 0.1°C
Confirm selection by pressing the PROG button.
If you are not sure, it is recommended to leave the total variation as +0.0°C (default setting).
Following any significant change in the ambient temperature (± 10°C) the thermometer should be left at room
temperature for at least 15 minutes before use to allow automatic recalibration of the device.
3. E S
XIT ETUP MODE
Press the PROG button until the screen switches off.
Visiomed - Kaufman KM-25 - V.2.3 -201012
S K
ETTING UP THE AUFMAN
KM-25
THERMOMETER
Menu Programming buttons
Body Mode Surface Mode Ambient
temperature
13/21