Configure Static Wep Security With Funk Security; Use Open (No Security) Associations With Funk Security - Honeywell Thor CV31 User Manual

Thor CV31 Vehicle-Mount Computer User Manual
Configure Static WEP Security with Funk
Security
Before you set static WEP security with Funk security, you need to enable
the radio on your computer and set the date. Intermec recommends that
you use WPA2-PSK instead of WEP if possible.
1 Start Intermec Settings.
2 Select Communications > 802.11 Radio > Funk Security.
3 Select a Funk security profile to configure.
4 Enter the SSID.
5 For Association, select Open.
6 For Encryption, select WEP.
7 For 8021x, select None.
8 Enter an ASCII key or hex key value for each key you want to use
(Key 1 through Key 4):
• For 64-bit WEP, enter a 5-byte value: 5 ASCII characters or 0x
followed by 5 hexadecimal pairs.
• For 128-bit WEP, enter a 13-byte value: 13 ASCII characters or 0x
followed by 13 hexadecimal pairs.
9 Select the Transmit key you want to use to transmit data.
10 Tap OK.
Use Open (No Security) Associations with Funk
Security
To create an open network, you can set no security with Funk security.
1 Start Intermec Settings.
2 Select Communications > 802.11 Radio > Funk Security.
3 Select the active Funk security profile.
4 Enter the SSID.
5 For Association, select Open.
6 For Encryption, select WEP.
7 Tap OK.
Chapter 3 — Configure the Computer
45