Download  Print this page

Advertisement

Care of Drain Air Gap
If a drain air gap was installed for your built-in
dishwasher, check to make sure it is clean so
the dishwasher will drain properly.
A drain air
gap is usually mounted on countertop
and can
be inspected by removing the cover. This is
not part of your dishwasher and is not covered
by warranty.
Property
Damage
Hazard
Freezing temperatures
may cause water
lines to rupture.
Be sure all supply lines to
and circulating
lines within dishwasher are
protected.
Failure to do so could result in property
See Installation
Instructions for more details
on disconnecting and restoring service to
Winterizing
A dishwasher left in an unheated place should
be protected from freezing.
Have a qualified
person do the following:
To Disconnect
Service:
1.
Turn off electrical power to the
dishwasher at the supply source by
removing fuses or tripping circuit breaker.
2.
Shut off water supply
3.
Place a pan under the inlet valve.
Disconnect water line from inlet valve
and drain into pan.
4.
Disconnect drain line from pump and
drain water into pan.
To Restore
Service:
1.
Direct water line discharge into a pan
and open the valve to flush the line.
2.
Reconnect the water, drain, and
electrical power supply.
3.
Turn on water and electrical power
supply.
4.
Fill both detergent
cups and run
dishwasher through a HEAVY WASH/
POWER PLUS cycle.
5.
Check connections
to make sure they
do not leak.

Advertisement

Table of Contents

This manual is also suitable for:

Fgid2466qf4a

Comments to this Manuals

Symbols: 0
Latest comments: