Download  Print this page

Advertisement

Glass Trap
emoval
To empty the glass trap"
1.
Grasp the glass trap's handle and rotate it
90o clockwise while pressing down on the
center of the wash arm.
2.
Grab the spray arm in the center and lift
the spray arm and glass trap assembly up
and out form the dishwasher.
3.
4.
Tip the assembly over an appropriate
container and tap it to empty the glass
trap.
OR, separate the glass trap - pull
the glass trap handle toward you, then
up, then further toward you to slide it
away from the rest of the assembly;
empty it into an appropriate
container;
then slide the glass trap back into the
assembly.
Place the assembly back into position,
press down on the arm at the center
and rotate the glass trap handle 90 °
counterclockwise
being sure the glass
trap ends in the orientation shown in the
image above.
To avoid damage
to
your
unit
make sure the spray arm
and glass trap
are fully
snapped in
place,
Burn Hazard
Allow heating element to cool before
cleaning the interior.
Failure to do so can result in burns.
Outel"
Pool"
= Clean outer door with warm
soapy water and a dishcloth or sponge.
Rinse
with clean water and a dry cloth.
Do not use
harsh cleaners.
Irlside
= The inside of the dishwasher and
filter are self-cleaning with normal use. If
needed, clean around the tub gasket area with
a damp cloth.
The filter is self-cleaning.
A
glass trap located in the center of the filter
is designed to collect pieces of broken glass,
straws, bones and pits.
Overfill
Protector
= keeps dishwasher
from overfilling
and is located in the left front
corner of the tub.
Clean occasionally with household cleaner
containing vinegar or bleach to dissolve
any buildup.
Overfill Protector should move up and
down freely about one inch. If it does not
move, lift and clean underneath.
Hard water may cause lime deposit buildup
on the interior of the dishwasher.
For
cleaning instructions see "Removing Spots
and film" section.

Advertisement

Table of Contents

This manual is also suitable for:

Fgid2466qf4a

Comments to this Manuals

Symbols: 0
Latest comments: