Precisionhd 1080P 12X; Line Voltage Frequency - Cisco PrecisionHD 1080p 12X User Manual

Cisco TelePresence PrecisionHD Camera
Contents Introduction

PrecisionHD 1080p 12X

The information on this page applies to the PrecisionHD 1080p
12X camera. The camera has DIP switches for video output
format setting.
NOTE: The early shipments of the Quick Set C20 came with
an interim version of the PrecisionHD 1080p 4X camera (the
PrecisionHD 1080p 4X* camera). The interim version has DIP
switches for video output format setting, see the table on this
page.
Video output formats
The DIP switches 1 to 5 sets the video output format for the
camera. The DIP switches are located on the underside of the
camera. The default setting is Auto, see the table to the right.
Maximum resolution:
•
1080p60 for PrecisionHD 1080p 12X zoom
•
1080p30 for PrecisionHD 1080p 4X* zoom
•
1080p30 for HD-SDI**

Line voltage frequency

The camera will automatically detect the line voltage frequency
when it is 50 or 60 Hz. If there is a different line voltage, you
can set the video output format to a specific value (use the DIP
switches) to override the auto frequency detection.
Set the PrecisionHD 1080p DIP switch (country specific
setting):
•
50Hz: 00011, gives 1080p50 (720p50 for HD-SDI)
•
60Hz: 00100, gives 1080p60 (720p60 for HD-SDI)
D14640.04 PrecisionHD 1080p-720p Camera User Guide
© 2010-2011 Cisco Systems, Inc. All rights reserved.
The physical interface
DIP switch table
1 2
0 0 0
0 0 0
0 0 0
0 0 0
0 0 1
0 0 1
0 0 1
0 0 1
0 1 0
0 1 0
PrecisionHD 1080p 12X, underside
, July 2011
.
Connecting the camera Video output formats Video output formats
DIP Switch table for video output formats
3 4 5 HDMI HD-SDI**
0 0 Auto
0 1 1920x1080p25 1920x1080p25
1 0 1920x1080p30 1920x1080p30
1 1 1920x1080p50** 1280x720p50***
0 0 1920x1080p60** 1280x720p60***
0 1 1280x720p25 1280x720p25
1 0 1280x720p30 1280x720p30
1 1 1280x720p50** 1280x720p50***
0 0 1280x720p60** 1280x720p60***
0 1 Software control
14
PrecisionHD Camera User guide
Daisy chaning Appendices
The table shows the different settings available
for the HDMI and the HD-SDI outputs.
Auto: Camera negotiates format over HDMI.
HD-SDI tracks HDMI and defaults to 1080p30 in
absence of HDMI sync.
Software: For more on the Software control
setting, read about video mode selections in the
Appendice section. Go to: Controlling cameras
using the VISCA™ protocol.
The DIP switches 1 to 5
0
1
* Available for a limited period of time.
** Not supported with Codec C20.
*** Do not use with the PrecisionHD 1080p 4X* camera.
www.cisco.com