System board
Description
System board for use in models without Windows 8.1
System board for use in models with Windows 8.1 Standard
System board for use in models with Windows 8.1 Professional
System board for use in NetClone models
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
When replacing the system board, make sure the following components are removed from the defective
system board and installed on the replacement system board:
●
Memory modules
●
Expansion cards
●
Heat sink
●
Processor
4.
Disconnect all cables connected to the system board, noting their location for reinstallation.
5.
Remove the six Torx screws that secure the system board to the chassis.
6.
Slide the system board toward the front of the computer to disengage the I/O panel, and then lift the
system board out of the computer.
When reinstalling the system board, first insert the I/O panel back into the slots in the rear of the chassis, and
then align the board with the chassis screw holes.
NOTE:
When replacing the system board, you must change the chassis serial number in the BIOS.
(Preparation for disassembly on page
(Access panel on page
(Memory on page
(Expansion cards on page
(Heat sink on page
39).
(Processor on page
40)
22).
25)
27)
21).
System board
49