Optical Drive Bezel Blank - HP 280 G1 Maintenance And Service Manual

Optical drive bezel blank

On some models, there is a bezel blank covering the optical drive bay. Remove the bezel blank before
installing an optical drive. To remove the bezel blank:
1. Remove the access panel
2. Remove the front bezel
3. To remove the bezel blank, press inward on the two retaining tabs on the side of the bezel blank that
hold the bezel blank in place (1) and rotate the bezel blank back to remove it (2).
24 Chapter 5 Removal and replacement procedures
(Access panel on page 22)
(Front bezel on page 23)