Troubleshooting; Maintenance; Service Information - Black & Decker GH3000 Instruction Manual

sure to wind the line on neatly and in layers. Do not crisscross figure S.
• When the wound cutting line reaches the recesses (R4), cut the line and dock it in the
spool line slots (R5) .
• Fit the spool cap onto the appliance as described in "REPLACING THE SPOOL" (figures
O, P).
Problem
• Unit will not start.
• Cutting line is consumed
quickly in edge mode.

MAINTeNANCe

WARNINg:
Disconnect the plug from the power source before performing any
maintenance.
CAUTION:
To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment should be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
1. Keep the air intake slots clean to avoid overheating.
2. Your trimmer line can dry out over time. To keep your line in top condition, store spare
pre-wound spools or bulk line in a plastic, sealable bag with a tablespoon of water.
3. Plastic parts may be cleaned by using a mild soap and a damp rag.
4. The line cutter on the edge of the guard can dull over time. It is recommended you
periodically touch-up the sharpness of the blade with a file.

SeRVICe INFORMATION

All Black+Decker Service Centers are staffed with trained personnel to provide customers with
efficient and reliable power tool service. Whether you need technical advice, repair, or genuine
factory replacement parts, contact the Black+Decker location nearest you. To find your local
service location call: 1-800-544-6986 or visit www.blackanddecker.com

TROUbLeSHOOTINg

Possible cause
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is
damaged.
• Edging too far from
edge of sidewalks or
abrasive surfaces. The
cutting line is hitting the
sidewalk or abrasive surface.
12
Possible solution
• Plug appliance into a working outlet.
• Replace circuit fuse. (If the product
repeatedly causes the circuit fuse to
blow, discontinue use immediately and
have it serviced at a Black+Decker
service center or authorized servicer.)
• Reset circuit breaker. (If the product
repeatedly causes the circuit breaker to
trip, discontinue use immediately and
have it serviced at a Black+Decker
service center or authorized servicer.)
• Have cord or switch replaced at Black
+Decker Service Center or Authorized
Servicer
• Ensure edging wheel is on the edge of
the surface and the cutting line is positioned
in the grass or dirt area to be edged not
the sidewalk or other abrasive surface.