Intended Use; Main Components; Assembly; Electrical Connection - Black & Decker PW1300TDW Instruction Manual

and understood the instructions in the manual
is forbidden.
f The introduction of inflammable, explosive and toxic
liquids into the appliance is prohibited.
f Use of the appliance in a potentially inflammable or
explosive atmosphere is forbidden.
f The use of non-original spare parts and any other
spare parts not specifically intended for the model in
question is prohibited.
Warning! All modifications to the appliance are prohibited.
Any modifications made to the appliance shall render the
Declaration of Conformity null and void and relieve the
manufacturer of all liability under civil and criminal law.
4. Service
a. Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
5. Electrical safety
Your tool is double insulated; therefore no earth
wire is required. Always check that the main
voltage corresponds to the voltage on the rating
plate.
Warning! If the power cord is damaged, it must
be replaced by the manufacturer, authorized
Black & Decker Service Center or an equally
qualified person in order to avoid damage or
injury. If the power cord is replaced by an equally
qualified person, but not authorized by Black &
Decker, the warranty will not be valid.
6. Labels on tool
The label on your tool may include the following symbols:
Read
instructions
manual
Poisoning
hazard
Injury
hazard
V ........
...... Class II
Construction
A ........
.... Safety Alert
Hz .......
Symbol
Warning! Safety signs. Comply with the instructions
provided by the safety signs ted to the appliance. Check
that they are present and legible; otherwise, replacements
in the original positions.
Danger of
Explosion
being beaten
hazard
by objects that
Electric shock
bounce
and short
Use eye
circuit hazard
protection
Short circuit
hazard
Wear proper
clothing
Volts W ........ Watts
Amperes min ..... minutes
Hertz ..... Alternating
Current
TECHNICAL INFORMATION
ENVISAGED USE
This appliance has been designed for individual use for
the cleaning of vehicles, machines, boats, masonry, etc, to
remove stubborn dirt using clean water and biodegradable
chemical detergents.
Vehicle enginesmay be washed only if the dirty water is
disposed of as per regulations in force.
f Intake water temperature: Seedata plate on
the appliance.
f Intake water pressure: Below 10 bar.
f Operating ambient temperature: Above 0 °C.
The machine complies with the EN 60335-2-79/A1.
MAIN COMPONENTS (Fig. A)
La máquina se entrega parcialmente desmontada dentro
de un embalaje de cartón.
1. Pressure washer
2. Power supply cable with plug
3. Handle
4. High pressure hose
5. Lance
6. Adjustable lance
7. Adjustable spray nozzle
8. Rotary lance
9. Gun with safety catch
10. Safety devices
11. Nozzle cleaning tool
Caution! Safety devices:
Do not tamper with or adjust the safety valve setting.
f Safety valve and pressure limiting valve:
The safety valve is also a pressure limiting valve.
When the gun trigger is released, the valve opens
and the water recirculates through the pump inlet.
f Safety catch (10): prevents accidental spraying of water.

ASSEMBLY

Caution! All installation and assembly operations must
be performed with the appliance disconnected from the
mains power supply.
The assembly sequence is illustrated in Fig. C.

Electrical connection

Caution! Check that the electrical supply voltage and
frequency (V-Hz) correspond to those on the appliance
data plate Fig. B. The appliance should only be connected
to a mains power supply equipped with an adequate earth
connection and a d erential security breaker (30mA) to cut
off the electricity supply in the instance of a short circuit.
ENGLISH • 17