Assemble the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
A. Upper trim piece (1)
B. Duct (1)
C. Lower trim piece (1)
Check the location where the microwave oven will be installed.
The location must provide the following:
Wood cabinet with opening as shown
Support for weight of 100 lbs (45.4 kg)
Grounded electrical outlet (see "Electrical Requirements"
section) on rear wall of cabinet enclosure
A. Cabinet opening
B. Location of grounded outlet
" (3 cm) clearance above
" (36.9 cm) height of
D. 4 mm x 8 mm tapping screws (7)
E. 4 mm x 16 mm tapping screws (4)
E. 1" (2.5 cm) min. clearance
" (51.8 cm) min. width of
G. 16" (40.7 cm) min. depth of
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Observe all governing codes and ordinances. A 120-Volt, 60-Hz,
AC-only, 15- or 20-amp fused electrical supply (or circuit breaker)
is required. (A time-delay fuse is recommended.) It is
recommended that a separate circuit serving only this appliance
For all cord connected appliances:
The microwave oven must be grounded. In the event
of an electrical short circuit, grounding reduces the
risk of electric shock by providing an escape wire for
the electric current. The microwave oven is equipped
with a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet that is
properly installed and grounded.
Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions
are not completely understood, or if doubt exists as to
whether the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord
is too short, have a qualified electrician or serviceman
install an outlet near the microwave oven.
For a permanently connected appliance:
This appliance must be connected to a grounded,
metallic, permanent wiring system, or an equipment
grounding conductor should be run with the circuit
conductors and connected to the equipment
grounding terminal or lead on the appliance.
SAVE THESE INSTRUCTIONS