Honeywell bendis king KLN 94 Maintenance Manual page 51

BENDIX/KING
H. If no failures are indicated, check "OK" on the Final Data Sheet.
5.2.4.10 ANNUNCIATOR OUTPUT TESTS
A. Using the Right inner knob bring up test page 9 (TST 9).
B. Press CRSR. Using right inner and outer knob, toggle the annunciators at the unit.
Check for a corresponding indication at the test harness.
DESCRIPTION
MESSAGE:
WAYPOINT
APPR ARM
APPR ACT:
FCS LOC ENG
VERT FLAG
LAT FLAG
FAN ENABLE
STEERING SUPERFLAG
C. When LATERAL DEV FLAG+ is set to 'ON' (invalid), TO/FROM shall be less than +
5 mV. (THTP13, THTP14)
D. The internal fan will turn on when commanded.
E. Current shall increase by (50 +/- 30) mA when the fan is on.
F. Press CRSR and then turn the Right inner knob to Next page 9. Page 9 will be dis-
played in three separate screens.
G. Press CRSR and toggle the outputs at the unit. Check for a corresponding indica-
tion at the test harness.
DESCRIPTION
SPARE ANN 1
SPARE ANN 2
H. If no failure is indicated, check "OK" on the Final Data Sheet.
5.2.4.11 SUPERFLAG OUTPUTS / Lateral and Vertical Flags
A. Set switches S34, S35 , S38 to the normal position.
B. Set S39 is set to the KLN94 position.
Page 5-12
Sounds produced by a proper working fan normally
do not indicate improper performance or mechanical
interference.
15599M00.JA
INDICATOR
DS2
DS1
DS3
DS4
DS8
THTP 6-7
THTP 6-7
DS9
NOTE:
INDICATOR
DS1
DS2
KLN 94
SWITCH SETTING
S3 set to SPARE
S3 set to Annunciate
S3 set to SPARE
S3 set to Annunciate
VERTICAL
LATERAL
SWITCH SETTING
S3 set to SPARE
S3 set to SPARE
Rev 0, Sept/2000