Download  Print this page

Electrical - Pioneer PDWB-5003 Installation Manual

Plasma display mount model.
Hide thumbs

Advertisement

To determine the desired viewing height, use the center slot opening in the wall mount as a center reference for the plasma television when mounted. Once the height is determined,
use the bubble level to insure that the bracket is level. Next, using a pencil, mark the four (4) lag bolt slot openings on the mounting bracket. Before continuing, confirm the marks are
located on the center of the studs.
Drill 1/4" pilot holes on the four (4) markings on the wall. Raise the flat back plate and have someone hold it in place (arrow side away from the wall and pointing up).
Put the lag bolt through the flat washers. Screw the lag bolt through the upper left slot opening into the 1/4" pilot hole. Confirm that the wall mount is still leveled and then screw a lag
bolt to the upper right side slot opening into the 1/4" pilot hole. Then install the remaining two lag bolts tightly into the wall studs in the lower left and right slot openings on the wall
mount. Lateral movement of approximately 1½" for final positioning is now possible. Make any positioning changes then secure the lag bolts. See fig 4.
Note: Pre drill before the securing the
5/16" lag bolts.
Drill gun with a 1/4"
drill bit
Wood studs behind
the wall structure
floor

Electrical

Step 4
All electrical wiring components should be installed at this time to ensure that the plasma display has enough power sources.
8
Caution: Do not over tighten the 5/16" lag bolts
5/16" Lag bolts
Marking on wall
Center of
viewing marks
Wall structure
floor
Flat washers
PDB-UWFB
(back plate)
Access holes

Advertisement

Table of Contents

   Related Manuals for Pioneer PDWB-5003

Comments to this Manuals

Symbols: 0
Latest comments: