Installation; Installation Considerations; Mounting Locations - Rockford Fosgate Power T15kW Installation & Operation Manual

INSTALLATION CONSIDERATIONS

Due to the weight and size of this amplifier, and for your safety and ease of mind, we strongly suggest you have this amplifier
installed by an Authorized Rockford Fosgate Dealer.
The following is a list of tools needed for installation:
Volt/Ohm Meter
Wire strippers
Wire crimpers
Wire cutters
Assorted Allen Wrenches
This section focuses on some of the vehicle considerations for installing your new amplifier. Pre-planning your system layout and best
wiring routes will save installation time.When deciding on the layout of your new system, be sure that each component will be easily
accessible for making adjustments.
CAUTION: If you feel unsure about installing this system yourself, have it installed by a qualified technician.
CAUTION: This amplifier weighs in excess of 195 lbs (88.4 kg).To prevent injury and/or damage to the unit, do
not lift, move, or reposition the unit without assistance.
CAUTION: Before installation, disconnect the battery negative (-) terminal to prevent damage to the unit, fire
and/or possible injury.
Before beginning any installation, follow these simple rules:
1. Be sure to carefully read and understand the instructions before attempting to install the unit.
2. For safety, disconnect the negative lead from the battery(s) prior to beginning the installation.
3. For easier assembly, we suggest you run all wires prior to mounting your unit in place.
4. Route all of the RCA cables close together and away from any high current wires.
5. Use high quality connectors for a reliable installation and to minimize signal or power loss.
6. Think before you drill! Be careful not to cut or drill into gas tanks, fuel lines, brake or hydraulic lines, vacuum lines or electrical
wiring when working on any vehicle.
7. Never run wires underneath the vehicle. Running the wires inside the vehicle provides the best protection.
8. Avoid running wires over or through sharp edges. Use rubber or plastic grommets to protect any wires routed through metal,
especially the firewall.
9. ALWAYS protect the battery and electrical system from damage with proper fusing. Install the appropriate fuse holder and fuse on
the +12V power wire within 18" (45.7 cm) of the battery terminal.
10. When grounding to the chassis of the vehicle, scrape all paint from the metal to ensure a good, clean ground connection.
Grounding connections should be as short as possible and always be connected to metal that is welded to the main body,
or chassis, of the vehicle.

MOUNTING LOCATIONS

Engine Compartment
Never mount this unit in the engine compartment. Mounting the unit in the engine compartment will void your warranty.
Trunk Mounting
air thermostatically controlled fan cooling system, this amplifier can be mounted to suit your personal
Due to the forced
preference. Just ensure adequate ventilation at the back, front and top of the amplifier for air flow (3" minimum).
Passenger Compartment Mounting
If you have enough room, mounting the amplifier in the passenger compartment will work as long as you provide a sufficient amount
of air for the amplifier to cool itself.
(3" minimum).
#2 Phillips screwdriver
Battery post wrench
Hand held drill w/assorted bits
1/8" diameter heatshrink tubing
Assorted connectors
Just ensure adequate ventilation at the back, front and top of the amplifier for air flow
I
NSTALLATION
Adequate Length—Red Power Wire
(1/0 AWG required)
Adequate Length—Black Grounding
Wire (1/0 AWG required)
Adequate Length—Remote Turn-on
Wire
7