Recording With Other Sources - Tascam DR-07 Quick Start Manual

• To record the sound of a source most effec-
tively and accurately, point the front of the
DR-07's built-in mics toward the sound source
with the LCD facing up.
7 Use the
OUTPUT LEVEL (+, –)
necessary to adjust the monitor volume.
8 Press the
RECORD
The key lights red.
9 Press the
STOP/HOME
The recorded data is saved as a new audio file
and the Home Screen appears on the display
again.
The playback position is set at the beginning of
the recorded audio file.
NOTE
• Press the RECORD key to pause recording
temporarily.
• Audio files recorded on the DR-07 are auto-
matically given a file name in the format
of "DR" followed by six digits assigned in
recording order. A file extension is added to
the end of the file name according to the file
type (.wav or .mp3). For example, if the first
recorded file is WAV type, the file is named
keys as
key again to start recording.
key to stop recording.
3–Recording
"DR000000.wav."

Recording with other sources

Instead of using the built-in microphone, you can
record using an external microphone or record the
output signal from a mixer, audio device or other
source.
To record a signal other than the built-in micro-
phone, connect the sound source to the appropriate
input jack on this unit. Set the
that sound source on the Input Setting screen
(refer to steps 1–4 of "Recording with the built-in
microphone" above).
All the procedures after making the input setting
are the same as steps 5–9 in "Recording with the
built-in microphone."
Recording a microphone with a
mini-plug connector
1 Connect the microphone to the
(stereo mini-jack) on the end of the unit.
item for
INPUT
jack
MIC IN
17
TASCAM DR-07