Brother MFC-J2720 Basic User's Manual page 62

Error Message
Out of Memory
Paper Jam [Front]
Paper Jam [Front,Rear]
Paper Jam [Rear]
(MFC-J5620DW)
Paper Tray not detected
(MFC-J2720/5720DW)
Paper Tray #1 not
detected
Paper Tray #2 not
detected
Touchscreen
Initialisation
Failed
54
Cause
The machine's memory is full.
The paper is jammed in the machine. Remove the jammed paper by
The paper tray is not completely
inserted.
Jammed paper or a foreign object has
prevented the paper tray from being
inserted properly.
The Touchscreen was pressed
before the power on initialization was
completed.
Debris may be stuck between the
lower part of the Touchscreen and its
frame.
Action
If a fax-sending or copy operation
is in process:
Press or Quit or Close and

wait until the other operations that
are in process finish, and then try
again.
 Press Send Now to send the
pages scanned so far.
 Press Partial Print to copy
the pages scanned so far.
 Clear the data in the memory. To
gain extra memory, you can turn
off Memory Receive.
(See Online User's Guide.)
 Print the faxes that are in the
memory.
(See Online User's Guide.)
following the steps. (See Printer jam
or paper jam on page 60.)
If there is a repeat paper jam, try
another paper jam operation.
(See Additional paper jam clear
operations on page 65.)
Slowly push the paper tray
completely into the machine.
Pull the paper tray out of the machine
and remove the paper or foreign
object. If you cannot find or remove
the jammed paper, follow the steps.
(See Printer jam or paper jam
on page 60.) Slowly push the paper
tray completely into the machine.
Make sure that nothing is touching or
resting on the Touchscreen,
especially when plugging in the
machine.
Insert a piece of stiff paper between
the lower part of the Touchscreen and
its frame and slide it back and forth to
push out the debris.