Brother KE-430FX Basic Operation Manual page 45

Select the item to be changed.
4
Pattern
5 Change the setting for the parameter.
(Refer to "List of parameters" on the next page for details
on parameter changes. ）
6 Apply the changed parameter setting.
Repeat steps 4 to 6 above to record the settings for each parameter.
7
8 If you would like to continue setting another program, repeat steps 2 to 7 above.
Exit program mode.
9
2404B
X-scale Y-scale Sewing speed
TEST indicator switches off
KE-430FX/KE-430FS, BE-438FX
6. USING THE OPERATION PANEL (BASIC OPERATIONS)
Press the SELECT key.
・ The selected parameter changes in the order shown in
the illustration below each time the SELECT key is
pressed.
Slow start pattern
Press the
setting.
・ The flashing display means that the parameter setting
has not yet been applied.
・ You can make the initial setting appear in the display
by pressing the RESET key.
2402B
Press the ENTER key.
・ The display will change from flashing to illuminated,
and this means that the setting has been applied.
・ If you press the SELECT key or the TEST key without
pressing the ENTER key, you can cancel the
parameter changes.
2403B
Press the TEST key.
・The display will return to the normal display.
Upper thread tension
or key to change the parameter
2401B
2382B 2383B
37