Enlarging Or Reducing The Copied Image - Brother DCP-J125 Advanced User's Manual

Enlarging or reducing the
copied image
You can choose an enlargement or reduction
ratio. If you choose Fit to Page, your
machine will adjust the size automatically to
the paper size you set.
a
Load your document.
b
Enter the number of copies you want.
c
Press a or b to choose
Enlarge/Reduce.
Press OK.
d
Press a or b to choose 100%, Enlarge,
Reduce, Fit to Page,
Custom(25-400%).
e
Do one of the following:
 If you chose Enlarge or Reduce
press OK and press a or b to choose
the enlargement or reduction ratio
you want. Press OK and go to
step f.
 If you chose Custom(25-400%),
press OK. Press a, b, d or c to select
a number, and then press OK
repeatedly until you complete to
enter the number.
Press a, b, d or c to select
press OK. Go to step f.
If you chose 100% or Fit to Page,

press OK. Go to step f.
198% 10x15cmiA4
3
186% 10x15cmiLTR
142% A5iA4
100%
97% LTRiA4
93% A4iLTR
83%
69% A4iA5
47% A4i10x15cm
Fit to Page
Custom(25-400%)
f
If you do not want to change additional
settings, press Mono Start or
Colour Start.
Note
• Page Layout is not available with
Enlarge/Reduce and Fit to Page.
• Fit to Page does not work correctly if
the document on the scanner glass is
skewed by more than 3 degrees. Using
the document guidelines on the left and
top, place your document in the upper left
hand corner, with the document face down
on the scanner glass.
OK , and
OK
Making copies
3
5