Replace Toner - Brother DCP-L2500D Basic User's Manual

Error Message
No Paper
No Toner
Print Unable XX
Replace Drum

Replace Toner

Scan Unable
Scan Unable XX
Cause
The machine is out of
paper, or paper is not
loaded correctly in the
paper tray.
The toner cartridge is not
installed or is not installed
correctly.
The machine has a
mechanical problem.
It is time to replace the
drum unit.
The drum unit counter was
not reset when a new drum
was installed.
The toner cartridge is at the
end of its life. The machine
stops all print operations.
While memory is available,
faxes are stored in the
memory.
The document is too long
for 2‑sided scanning.
The machine has a
mechanical problem.
Action
Do one of the following:
• Refill paper in the paper tray. Make
sure the paper guides are set to
the correct size.
• Remove the paper and load it
again. Make sure the paper guides
are set to the correct size.
• Make sure not to overfill the paper
tray.
Remove the drum unit and toner
cartridge assembly. Install the toner
cartridge in the drum unit correctly.
Reinstall the toner cartridge and drum
unit assembly in the machine. If the
problem continues, replace the toner
cartridge.
• Press and hold
machine, wait a few minutes, and
then turn it on again.
• If the problem continues, contact
Brother customer service.
Replace the drum unit.
Reset the drum unit counter.
See the instructions included with the
new drum unit.
Replace the toner cartridge with a
new one.
Press Stop/Exit. Use an appropriate
size paper for 2‑sided scanning.
• Press and hold
machine, and then turn it on again.
• If the problem continues, contact
Brother customer service.
to turn off the
to turn off the
48