Honeywell evohome Installation Manual page 9

Mounting BDR91
Mounting BDR91
• Open the BDR91 relay module by
inserting a screwdriver in the opening at
the bottom.
The wiring can be led in either from the rear
or from the left hand side.
< 7mm
• If entry from the left hand side is desired,
cut suitable holes in the appropriate
plastic breakouts.
• Install the BDR91 relay module mounting
Wiring the BDR91 relay module
• Connect the wires of the power supply
Closing BDR91 relay module
• Hinge the front piece of the BDR91 relay
> 7mm
plate in the chosen location.
and the boiler/valve control to the
terminals on the BDR91 mounting plate
according to the selected application
(see application diagrams).
module onto the mounting plate and
press until it clicks securely into place.
= M3.5
o
= N 6
9