Table of Contents
Advertisement
Print Head Maintenance
Follow the procedure shown below to maintain the print head.
1.
Make a test print, and check the image quality (status of the print head).
Making a Test
Print, p. 3-19
2.
Step 2 Clean the print head.
Cleaning the Print
3.
Step 3 Make a test print again, and check the image quality (status of the print head).
Making a Test
Print, p. 3-19
4.
Step 4 If the problem is not resolved, replace the print head.
Replacing a Print
5.
Step 5 After replacing the print head, carry out calibration.
Replacing a Print
Making a Test Print
1.
On the System Administrator Menu screen, press Print Head Maintenance > Test Print.
For information on how to display the System Administrator Menu screen, refer to
Administrator Menu Settings Overview
2.
Select a type of paper to be used for test printing, and press Start.
Note
Manual feed cannot be selected.
Xerox® Wide Format IJP 2000
User Guide
Head, p. 3-20
Head, p. 3-9
Head, p. 3-9
on page 5-2.
Daily Management and Maintenance
System
3-19
Advertisement
Table of Contents
