Table of Contents
Advertisement
1.5
Replacing the card bracket
The PEB-10G Series Ethernet card is bundled with a full-length bracket, a low-profile bracket,
and an ASUS proprietary bracket. By default, the card is pre-installed with a full-length
bracket.
The proprietray bracket supports ASUS Z10PH-D16 series, ES4000 G3 series, and
RS720Q-E8 series models, etc. The supported list of models are subject to change without
prior notice.
To replace the card bracket:
1.
Get the PEB-10G Series Ethernet card and place it on a stable and flat surface.
Ensure that the printed circuit board (PCB) is facing down.
2.
Remove the two screws that secures the PEB-10G Series Ethernet card to the card
bracket then remove the card bracket.
default card bracket
3.
Get the replacement card bracket.
4.
Align and insert the PEB-10G Series Ethernet card into the mounting hole of the card
bracket. Ensure that the screw holes on the PEB-10G Series Ethernet card matches
the screw holes of the card bracket.
5.
Replace the screws that you removed earlier in step 2.
replacement card bracket
1-4
screw
screw
screw
screw
Chapter 1: Product introduction
Advertisement
Table of Contents
