Honda 2006 CR-V Owner's Manual page 209

Main Menu Table of Contents
Lights
SCREW
2. Use a Phillips-head screwdriver to
remove the taillight assembly
mounting screw under each cover.
3. Pull the taillight assembly out of
the rear pillar.
206
BULBS
4. Determine which of the four bulbs
is burned out: stop/taillight, back-
up light, turn signal, or side
marker.
Remove the socket by turning it
5.
one-quarter turn counterclockwise.
6. Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
7. Reinstall the socket into the light
assembly by turning it clockwise
until it locks.
8. Turn on the lights to make sure
the new bulb is working.
9. Align the clips on the taillight
assembly with the holes in the
body, then push the taillight
assembly into place. Tighten the
two mounting screws securely and
reinstall the covers.