Mitsubishi Electric PURY-WP200 Service Manual page 182

[ IX Troubleshooting ]
1. Error Code
6607
No ACK error
2. Error definition and error detection method
The error is detected when no acknowledgement (ACK signal) is received after the transmission. (eg. When the data is trans-
mitted six times in a row with 30 seconds interval, the error is detected on the transmission side.)
The address/attribute appeared on the display on the remote controller indicates the controller which did not provide
the response (ACK).
3. System configuration
(3) System connected to the system controllers (MELANS)
Error
source Error display
address
Out- ME remote
door controller (RC)
unit System control-
(OC) ler (SC)
MA remote
controller (MA)
HBC ME remote
control- controller (RC)
ler system control-
(HB) ler (SC)
MA remote
controller (MA)
HWE1113B
Detection
method
No acknowl- Same cause as that for system with one
edgement outdoor unit
(ACK) at IC
transmis-
sion to OC
No acknowl- Same cause as that for system with one
edgement outdoor unit
(ACK) at IC
transmis-
sion to HB
- 173 -
Cause Check method and remedy
Same remedy as that for
system with one outdoor
unit
Same remedy as that for
system with one outdoor
unit
GB