Pride Go-Chair Owner's Manual page 32

V I I .
To replace the wheel:
1. Turn off the power to the controller.
2. Set the Go-Chair up on blocks.
3. Remove the drive wheel nut and washer from the axle. See figure 22.
4. Pull the wheel off the axle.
5. Slide the new wheel back onto the shaft. Make sure that the key is in the axle slot.
6. Reinstall the drive wheel nut and washer onto the axle and tighten.
7. Remove the Go-Chair from the blocks.
Battery Replacement
A battery wiring diagram is printed on a decal lo-
cated on the front battery tray. See the Specifica-
tions Table for correct battery specifications.
WARNING! Battery posts, terminals,
and related accessories contain lead
and lead compounds. Wear goggles
and gloves when handling batteries
and wash hands after handling.
WARNING! The batteries in your
travel chair should only be serviced
or replaced by an authorized Pride
Provider or a qualified technician.
W A R N I N G ! D o n o t r e p l a c e t h e
batteries when seat is occupied.
WARNING! Travel chair batteries are
heavy. See specifications table. If
you are unable to lift that much
weight, be sure to get help. Use
proper lifting techniques and avoid
lifting beyond your capacity.
WARNING! Do not mix or match new
and old batteries. If you encounter a
situation where one battery needs to
be replaced, then replace both
batteries. Refer to specifications
table in this manual and the manual
supplied with the battery charger for
recommended type and capacities.
To replace the batteries:
1. Remove the battery box from the Go-Chair.
2. Turn the pack upside down.
3. Remove all screws that hold the battery box halves together. See figure 23.
4. Flip the battery box back over so the handle is up and remove the lid.
5. Remove the red (+) positive and black (-) negative battery leads from each battery.
6. Remove the batteries.
7. Put the new battery or batteries back into the battery box (battery terminals up).
32
C A R E A N D
www.pridemobility.com
M A I N T E N A N C E
Figure 23. Go-Chair Battery Box
Go-Chair