Call Tone; Roger Beep; Key Beep - Uniden UH720SX-NB Owner's Manual

Operation

Call Tone

Your UH710SX-NB/UH720SX-NB radio is equipped with 5 selectable call tones
that will be transmitted when
1. Press eight times. The current call tone setting flashes.
2. Press or
The 5 call tones are C1, C2, C3, C4 and C5.
3. Press and hold
Current regulations require calling tones to be restricted to one
transmission per minute. If a second transmission is attempted
within one minute then an error tone will sound.
NOTE

Roger Beep

Roger Beep is a BEEP that is sent to notify the end of transmission (both PTT
and VOX transmission.) Roger Beep can be heard through the speaker when
Key Beep is on. Roger Beep is transmitted even if Key Beep is turned off.
However, Roger Beep will not be heard from the speaker.
1. Press nine times. The current Roger Beep setting flashes.
2. Press or
3. Press and hold

Key Beep

Assures the user that the keypad has been properly pressed by emitting a
beep tone. This tone can be switched on or off.
1. Press ten times. The current Key Beep setting flashes.
2. Press or to change selection.
3. Press and hold
UNIDEN UH720SX-NB/UH710SX-NB
is pressed and held.
to select desired setting.
to save and exit.
to select desired setting.
to save and exit.
to save and exit.
23
UHF CB Radio