Disassembly And Assembly - Pride Hurricane Owner's Manual

V I I I . D I S A S S E M B L Y A N D A S S E M B L Y
No tools are required to disassemble or assemble your Hurricane. Always disassemble or assemble your Hurricane
on a level, dry surface with sufficient room for you to work and move around your scooter. Keep in mind that the
disassembled sections of the Hurricane take up more floor space than the assembled scooter.
DISASSEMBLY
You can disassemble the Hurricane into seven pieces: the seat, the front section, the rear section, the rear shroud,
the basket, and the batteries. Place the Hurricane in an area where you have sufficient clearance to move the parts
around. You need about two meters in all directions. You may need assistance to lift some of the Hurricane
components. See III. “Specifications” for individual component weights.
1. Place the manual freewheel lever in the drive (down) position.
2. Coil the charger power lead and store it in the rear storage compartment. See figure 7.
3. Pull up on the seat lock lever to unlock the seat. Rotate the seat one eighth of a turn, and lift the seat up and off
the Hurricane. See figure 18.
4. Gently lift the rear shroud off of the Hurricane. See figure 19.
FIGURE 18. SEAT REMOVAL
5. Disconnect the battery tie-down strap.
6. Unplug both black and white 2-pin battery harnesses. See figure 20.
7. Unplug the silver front-to-rear harness that connects the control console assembly to the electronics module.
See figure 21.
FIGURE 20. DISCONNECTING THE BATTERY HARNESSES
CAUTION!
disassembly could result in permanent damage to the Hurricane.
Hurricane
Failure to unplug both battery harnesses and the front-to-rear harness prior to
FIGURE 19. REAR SHROUD REMOVAL
FIGURE 21. DISCONNECTING THE FRONT-TO-REAR
HARNESS
33