Before Use - Kenwood HD Radio KTC-HR200 Instruction Manual

Before use

2WARNING
To prevent injury or fire, take the following
precautions:
• To prevent a short circuit, never put or leave any
metallic objects (such as coins or metal tools) inside
the unit.
Cleaning the Unit
If the faceplate of this unit is stained, wipe it with a
dry soft cloth such as a silicon cloth.
If the faceplate is stained badly, wipe the stain off with
a cloth moistened with neutral cleaner, then wipe it
again with a clean soft dry cloth.
Notes
• If you experience problems during installation,
consult your Kenwood dealer.
• The illustrations of the display and the panel
appearing in this manual are examples used to
explain more clearly how the controls are used.
Therefore, what appears on the display in the
illustrations may differ from what appears on the
display on the actual equipment, and some of the
illustrations on the display may be inapplicable.
Control Units that can be Connected
For the models to which this unit can be connected,
consult your Kenwood dealer.
Note that the following restrictions may occur
depending on a control unit to be used.
• The HD Radio cannot be selected as a dual zone
source.
How to operate the unit
Operations of this unit are described in the instruction
manual of a control unit. For those not described in it,
refer to the following <Operations> section.
• CD Receiver: <Operations –CD Receiver–> page En-
4
• KVT-512, DDX512, DNX5120, DNX512EX
: <Operations –DVD monitor 1–> page En-8
• DDX812, DDX712, DNX8120, DNX7120
: <Operations –DVD monitor 2–> page En-11
⁄
• Following models are Multi key system models. Operations
different from those of a standard model may be described
in the <Operations –CD Receiver–> section.
KDC-MP728, KDC-MP828, KDC-X789,KDC-X889
• The display of the capital and small letters may be differed
depending on the model.
En-3
|
English