Download  Print this page

Protection Circuitry - Kenwood VRS-7100 Instruction Manual

Audio video surround receiver
Hide thumbs

Advertisement

Setting up the system
For Europe and Australia
CAUTION
Make sure that the power cord plug is disconnected from the AC
wall outlet before proceeding to speaker cord connections.
If the conductor wires on the extremity of speaker cord are
untwisted, there is a risk of short-circuiting. Be sure to twist
them well before connecting the speaker cord.
Front Speakers
Right
R
FRONT
14
EN
Left
Center
Speaker
SPEAKERS (6-8Ω)
CENTER
SURR R
SURR BACK
SURR L
/SW
L
Whether each speaker is connected properly can be
confirmed by outputting the test tone and checking if
each speaker channel outputs audio. For details, see
"Speaker settings" (Step
level). §

Protection circuitry

This unit incorporates protection circuitry, which may be activated
during high-power reproduction or in case of extreme rise in tempera-
ture.
When the protection circuitry is activated, the output from this unit is
shut down and the STANDBY indicator blinks.
In this case, turn this unit OFF then ON again and reduce the output
volume level.
Surround Speakers
Be sure to connect both surround speakers
Subwoofer/ Surround Back Speaker
When the surround back speaker is connected to these
terminals, set the speaker setting to "BS/SW BS".
In this case, the subwoofer should be connected to the
PRE OUT SUBWOOFER jack ^
Right
Left
6
Adjust the speaker volume

Advertisement

Table of Contents
loading

  Also See for Kenwood VRS-7100

  Related Manuals for Kenwood VRS-7100