Sp Distance; Identifying Components For Remote Control Unit; Sp Level - Kenwood VR-4090 Connect And Set Up

Chapter Two : Setting Up the Remote Control Unit

SP Distance

Measure the distance from each speaker to the seat you most
often use. Note the distance in the table below:
Speaker Distance (m or ft)
Left front
Center
Right front
Right surround
Left surround
Subwoofer
38
After the speaker setup, it is required to make Remote Con-
trol unit capable of identifying the devices it controls. Re-
mote Control unit provided with the receiver can be used
in setup of any device. Even when a device is not listed in
the device codes in the Remote Control unit memory, the
remote control function of the device can be programmed
using the Learn function.
The Learn function can also be used to extend the remote
controllable functions.
For details, see "If a device cannot be remote controlled with
any code in the list, or to add remote control target func-
tions..." below.
Registering a device
1. Ensure that the batteries are loaded.
1. In step 8 of the SP Level setting procedure above, select
Next (LCD function key 2).
Surround SetUp
Distance = L
9.0m/30ft
Home Next
2. Set the distance of the L (left front) speaker using the
or key.

Identifying Components for Remote Control Unit

Press the Music key or Movie key to display "Menu".
Tuner
FM 01ch
87.50MHz
Menu
2. Press the Menu key (LCD function key 2).
Home Setup
3. Press Next and set the distance of the next speaker (C =
Center) speaker.
4. Set the distances of all the speakers in the system.
R: Front Right speaker
RS: Right Surround speaker
LS: Left Surround speaker
SW: Subwoofer
5. Press the Home key (LCD function key 2) to return to
the normal operation screen.
3. Press the Setup key (LCD function key 2).
01.IR
02.Surround
03.Contrast
Home Enter
4. Select "01. IR" using the or key, then press the
Enter key (LCD function key 2).