Reprogramming The Call Channel - Kenwood TH-K2AT Instruction Manual

Reprogramming the Call Channel

1 Select your desired frequency and related data
(Tone, CTCSS, DCS, or offset direction, etc.).
• When you program the Call Channel as an odd-split
channel, select a reception frequency first.
2 Press [F], [CALL].
• The selected frequency and related data are stored in
the Call Channel.
To also store a separate transmit frequency, continue
with the following steps.
3 Select the desired transmission frequency.
4 Press [F].
5 Press [PTT]+[CALL].
• The separate transmission frequency is stored in the
Call Channel.
Note:
When you recall an odd-split Call Channel, "+" and "–" appear on
the display.
Transmit offset status and Reverse status are not stored in an
odd-split Call Channel.
54