Safety Information - Lenovo px2-300d User Manual

Setting up Your px2-300d Network Storage

Safety Information

Observe the following guidelines when using your px2-300d Network Storage:
Follow all instructions marked on the px2-300d and in the documentation.
●
Use only the power supply provided with the px2-300d.
●
Unplug the px2-300d before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for
●
cleaning.
Do not use the px2-300d near water. Do not spill liquid on or into the px2-300d.
●
Do not place the px2-300d on an unstable surface.
●
Do not place the px2-300d near or on a radiator or heat register.
●
Openings in the px2-300d are provided for fans and air ventilation and should not be blocked or
●
covered. Make sure the px2-300d has ample ventilation (at least 6 inches or 127 mm) in front and
behind the unit.
Do not walk on the power cord or allow anything to rest on it.
●
There is a danger of explosion if the coin cell lithium battery is incorrectly replaced. Replace only
●
with the same or equivalent type recommended by the equipment manufacturer. Dispose of used
batteries according to local, state, regional, and federal regulations.
Under any of the following conditions, unplug the px2-300d from the wall outlet and contact technical
support:
The power cord or plug is damaged.
●
Liquid has been spilled into the device.
●
The device does not function properly when the operating instructions are followed.
●
The device was dropped or the exterior enclosure is damaged.
●
8 Safety Information