Removal steps of the wireless WAN card
Note: The wireless WAN card is only available on some models.
In step
1
, unplug the connectors by using the antenna RF connector removal tool or pick up the connectors
with your fingers and gently unplug them as shown.
When installing: Plug the red cable into the main connector, and the blue cable into the auxiliary connector
on the card.
Step
Screw (quantity)
2
M1.6 × 2.0 mm, flat-head, nylon-coated (1)
1090 Camera-card cable
For access, remove this FRU:
•
"1010 Back cover assembly and smart card reader" on page 44
56
Hardware Maintenance Manual
1
1
Color
Silver
Torque
0.098 Nm
(1.00 kgf-cm)