Select an input source other than
To select the CD input
Pause the recording
÷ Press the rec key during recording. It pause after
leaving a non-recorded blank of 4 seconds. (Press
the key again to resume recording.)
3. Set the recording condition.
Select the reverse mode. (
÷ Check the tape transport direction before starting recording. If it is set to
the reverse direction, only one side of tape can be recorded regardless of
the reverse mode setting made here.
÷ The tape equalizer is defeated during recording.
4. Select the source to be recorded.
AUX (External input) [Adjusting the AUX input level ﬂ]
÷ If a CD has already been
loaded, it starts to play
now. Press the 7 key to
5. Start recording.
Press the rec key.
Play (or tune) the input source to be recorded.
While recording an AM broadcast, beat sound can be minimised by
switching the BEAT switch on the CD tray.
÷ Recording stops automatically when the tape side (s) to be recorded have
been fully recorded.
Stop the recording
The character information display shows the re-
cording input source.
Select 1 or 2.
Recording on TAPE