Kenwood HM HM-332 Instruction Manual page 19

Kenwood owner's manual micro hi-fi component system hm-332
Hide thumbs Also See for HM HM-332:
Table of Contents

Advertisement

To wind tape at high speed
To fast wind in
direction |
4
÷ Press the 7STOP key to stop fast winding.
Selection of TAPE equalizer (TAPE EQ.)
(Remote control unit only)
When playing a tape prerecorded with Noise Reduc-
tion system (such as the DOLBY NR) ON, be sure to
set the "TAPE EQ." ON for playback.
TAPE EQ.
Lit when "TAPE EQ." is ON
Each press switches the modes as follows.
1 "TAPE EQ." ON
2 "TAPE EQ." OFF
÷ Select the "TAPE EQ." ON mode according to the
recording condition of the tape.
T
÷ Normal (TYPE ), high (TYPE ), or metal (TYPE
selection is set automatically.
÷ Remove tape slack before loading.
Reverse mode indication
T
Transport direction indicators
Displayed when the deck is loaded with a tape.
To fast wind in
direction \
¢
TAPE EQ.
TAPE equalizer is used.
TAPE equalizer is not used.
0000
APE
STOPR W
E
) tape
Tape counter
0152
APE
PLAYR W
E
To stop playback
STOP
7
Selection of reverse mode
1Select "TAPE RVS. ?".
menu
set/demo
(Press the set/demo key while the "?" mark
is blinking.)
2 Select.
volume/
multi control
down
1
" " : (REVERSE)
Both sides are played back (recorded), and then the
tape stops.
"
":
2
(ENDLESS)
Both sides are played back endlessly.
(The tape stops after recording onto both sides.)
3
" ": (ONE-WAY)
Only one side is played back (recorded), and then
the tape stops.
(The initial setting is " " (REVERSE).
3 Set it.
set/demo
A tip for use of the tape counter
The tape counter is set to "0000" when a cassette tape is
loaded. By writing down the counter reading in case you
want to interrupt recording (playback) in the middle of
the tape, the memo will be helpful as a reference for lo-
cating the same position when continuing the recording
(playback) the next time. The tape counter figure decre-
ments during recording or playback of the back side (while
the 2 tape transport indicator is lit). To set the tape
counter to "0000", open the cassette holder once. Then
the counter will be reset.
Do not use a cassette with more than 90-minute re-
cording time, for the tape used with such a cassette
is very thin and tends to cause troubles such as en-
tanglement around the pinch roller or cutting of
tape.
Playback of tape
(Main unit only)
up
volume/
multi control
down
up
19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents