Download  Print this page

Normal Playback; Preparing For Playback; Listening To A Source Component - Kenwood VR-606 VR-616 Instruction Manual

Kenwood audio video surround receiver instruction manual
Hide thumbs

Advertisement

Normal playback

Preparing for playback

Some preparatory steps are needed before starting playback.
SPEAKERS
POWER
ON/OFF
ON/STANDBY
AUTO
INPUT MODE
Turning on the receiver
1 Turn on the power to the related components.
2 Turn on the power to this receiver by pressing POWER ON/
STANDBY
key.
Selecting the input mode
If you have selected a component connected to the CD/DVD, VIDEO 2
or DVD/6CH jacks, make sure that the input mode setting is correct for
the type of audio signal to be used.
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is "TAPE". To change the
source to "MD", follow the steps below:
1 Use the INPUT SELECTOR knob to select "TAPE".
2 Hold down the AUTO key for more than 2 seconds.
• The source indication changes to "MD".
• To return to the original indication, repeat procedure 2.
Setting the speaker status
The speaker indicator lights up.
Press the SPEAKERS ON/OFF key to switch the speakers ON or
OFF.
INPUT SELECTOR
7

Listening to a source component

INPUT
SELECTOR
1
Use the INPUT SELECTOR knob or keys to select the source
you want to listen to.
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob.
1 "AUX"
2 "TUNER"
3 "CD/DVD"
4 "TAPE" or "MD"
5 "VIDEO 1"
6 "VIDEO 2"
7 "DVD/6CH"
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or VOLUME +/- keys to
adjust the volume.
VOLUME CONTROL
INPUT SELECTOR
VOLUME + / –
17
EN

Hide quick links:

Advertisement

Table of Contents
loading

  Also See for Kenwood VR-606 VR-616

  Related Manuals for Kenwood VR-606 VR-616

This manual is also suitable for:

Vr-616