Miele PG 8050i Installation Instructions Manual page 13

Professional dishwasher
Hide thumbs Also See for PG 8050i:
Table of Contents

Advertisement

^ Tape the bracket to the door panel to
hold it in place while the mounting
holes are being drilled.
^ Proceed to step "Drill pilot holes ...".
If the adjacent cabinetry (or
appliance) does not have drawers
and alignment to a drawer line is im-
possible:
^ Hang the bracket on the machine
door, without the templates, and
tighten the four locking screws on the
edges of the door panel.
^ Close the door.
^ Measure the distance from the
adjacent cabinet (or appliance) door
bottom to the bottom of the mounting
bracket (X).
^ Using measurement (X), draw a line
on the rear of the door panel (X)
inches up from the bottom.
^ Remove the bracket from the
machine door and place it on the rear
of the door panel so that:
– the bracket is centered left to
right,
and
– the bottom of the bracket is
aligned with the (X) line.
^ Tape the bracket to the door panel to
hold it in place while the mounting
holes are being drilled.
^ Drill pilot holes for the screws using a
3/32" (2.5 mm) bit.
^ Attach the bracket to the panel using
the 6 screws provided.
^ Remove the templates (if used).
The templates should be kept in
case you want to install a different
door panel on the dishwasher at a
later date.
Installation
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents