Pyrolytic Cleaning ^ Of The Oven Interior; Setting Up For Pyrolytic Cleaning - Miele H 6460 BP Operating And Installation Instructions

Pyrolytic cleaning ^ of the
oven interior
Instead of cleaning the oven manually
you can run the Pyrolytic cleaning
programme ^.
During pyrolytic cleaning the oven
interior is heated up to over 400 °C. Any
residual soiling is broken down and
reduced to ash by the high
temperatures.
This oven has three levels of pyrolytic
cleaning, each with a different duration.
Select:
– Level 1 for light soiling
– Level 2 for heavier soiling
– Level 3 for very heavy soiling
For safety reasons the oven door is
automatically locked at the beginning of
the Pyrolytic cleaning programme.
It cannot be opened until the
programme has finished.
The timer can be used to delay the start
time of the Pyrolytic cleaning
programme, for instance to make use of
cheaper electricity tariffs.
At the end of the Pyrolytic cleaning
programme any residues such as ash
from the pyrolytic process can be easily
wiped away.
Cleaning and care

Setting up for pyrolytic cleaning

The high temperatures used during
pyrolytic cleaning will damage
accessories that are not designed
for pyrolytic cleaning.
Please remove these accessories
from the oven interior before starting
pyrolytic cleaning. This also applies
to non-pyrolytic accessories
purchased separately to the oven.
The following accessories are suitable
for pyrolytic cleaning and can be left in
the oven:
– Side runners
– FlexiClip telescopic runners HFC72
– Rack HBBR72
^ Take all non-pyrolytic accessories out
of the oven.
^ Place the rack on the top shelf level.
If not removed coarse soiling can
smoke and cause the pyrolytic
cleaning process to switch off.
^ Coarse soiling should be removed
before running the Pyrolytic cleaning
programme.
99