Table of Contents
Advertisement
For availability of approved
enhancements, please check with
your dealer. When you disconnect
the power cord of any enhancement,
grasp and pull the plug, not the cord.
1. Open the flap on the bottom of
the phone.
2. Connect the charger to a wall
socket.
3. Connect the lead from the
charger to the socket on the
bottom of your phone.
If the battery is completely
discharged, it may take a few
minutes before the charging
indicator appears on the display, or
before calls can be made.
The charging time depends on the
charger and the battery used. For
example, charging a BL-5B battery
with the ACP-12 charger takes
approximately 1 hour and 10
minutes while the phone is in the
standby mode.
Copyright © 2006 Nokia. All rights reserved.
■ Switch the phone on
and off
Warning: Do not switch the
phone on when wireless
phone use is prohibited or
when it may cause
interference or danger.
Press and hold the power key.
If the phone asks for a PIN or a UPIN
code, enter the code (displayed as
****), and select OK.
Turn off the phone when replacing
the battery or SIM card. Wait until
the backlights are off before
removing the battery.
Your device has an
internal antenna.
Note: As with any
other radio
transmitting
device, do not
touch the antenna unnecessarily
when the device is switched on.
Contact with the antenna affects
call quality and may cause the
device to operate at a higher power
level than otherwise needed.
Avoiding contact with the antenna
area when operating the device
optimizes the antenna performance
and the battery life.
G e t s t a r t e d
3
Advertisement
Table of Contents
