Error Mode - Pioneer DEH-3900MP Service Manual

1

6.3 ERROR MODE

- Error Messages
If a CD is not operative or stopped during operation due to an error, the error mode is turned on and cause(s) of
A
the error is indicated with a corresponding number. This arrangement is intended at reducing nonsense calls from
the users and also for facilitating trouble analysis and repair work in servicing.
(1) Basic Indication Method
1) When SERRORM is selected for the CSMOD (CD mode area for the system), error codes are written to DMIN
(minutes display area) and DSEC (seconds display area). The same data is written to DMIN and DSEC. DTNO
remains in blank as before.
2) Head unit display examples
B
Depending on display capability of LCD used, display will vary as shown below. xx contains the error number.
8-digit display
(2) Error Code List
Code Class
10 Electricity
C
11 Electricity
12 Electricity
17 Electricity
D
30 Electricity
44 Electricity
50
Mechanism
A0 System
Remarks: Mechanical errors are not displayed (because a CD is turned off in these errors).
E
Unreadable TOC does not constitute an error. An intended operation continues in this case.
Upper digits of an error code are subdivided as shown below:
1x: Setup relevant errors, 3x: Search relevant errors, Ax: Other errors.
F
48
1
2
ERROR–xx
Displayed error code Description of the code and potential cause(s)
Carriage Home NG CRG can't be moved to inner diameter.
SERVO LSI Com- CRG can't be moved from inner diameter.
→ Failure on home switch or CRG move mechanism.
munication Error
Communication error between microcomputer and SERVO LSI.
Focus Servo NG Focusing not available.
→ Stains on rear side of disc or excessive vibrations on REWRITABLE.
Spindle Lock NG Spindle not locked. Sub-code is strange (not readable).
→ Failure on spindle, stains or damages on disc, or excessive vibrations.
Subcode NG
A disc not containing CD-R data is found.
Turned over disc are found, though rarely.
CD signal error.
Setup NG AGC protection doesn't work. Focus can be easily lost.
→ Damages or stains on disc, or excessive vibrations on REWRITABLE.
Search Time Out Failed to reach target address.
→ CRG tracking error or damages on disc.
ALL Skip Skip setting for all track.
(CD-R/RW)
CD On Mech Error Mechanical error during CD ON.
→ Defective loading motor, mechanical lock and mechanical sensor.
Power Supply NG Power (VD) is ground faulted.
→ Failure on SW transistor or power supply (failure on connector).
DEH-3900MP/XN/EW5
2
3
6-digit display
ERR–xx
3
4
4-digit display
E–xx
4