Using the inner connector(s)
Turn the projector off by pressing
minutes to cool down. Disconnect the power cord.
Use a screwdriver to remove the screw(s) from the cover. (Illustration #1)
Push up and remove the cover. (Illustration #2)
Locate the HDMI (MHL) connector beside the focus/zoom ring.
Put the bottom of the WirelessHD dongle (optional accessory) or other
HDMI/MHL dongle into the projector first (Illustration #3) and then insert
the WirelessHD dongle into the HDMI (MHL) connector. (Illustration #4)
A micro USB cable is also available if you need to power the HDMI/MHL
Replace the cover and tighten the screw(s). (Illustration #5 - #6)
(POWER). Allow the projector at least 45