Bernina 700D Owner's Workbook page 68

M
ASTERING
Y
OUR
BERNINA
®
• Owner's manual pg.___
• Attach the 2-thread adapter to the upper looper. Note: This is an optional accessory for the 700D.
• Following the instructions in the Owner's manual thread the serger for a 2-thread wrapped edge
using Jeans Stitch
• Place the fabric under the presser foot and serge along one edge; adjust the differential feed
function if needed.
• If the Jeans Stitch
tension. If the thread still does not wrap, remove the Jeans Stitch
thread guide and try again. Wrap-stitch the other three edges of the fabric.
• Use seam sealant to seal the stitching at the corners. When the sealant is dry, trim the thread tails.
• Return stitch length and thread tension levers to normal.
• Trim and mount the sample.
BERNINA
M Y
ASTERING OUR
WRAPPED EDGE
Fabric:
Needle:
Thread:
Presser Foot:
® thread in the lower looper. Set tension levers as directed.
®
does not wrap, the thread tension may be too tight. Reduce the looper thread
1/04/02
®
BERNINA
Heavy wool or polar fleece, 5" x 6"
80/12 Stretch
1 cone of serger thread
1 cone of Jeans Stitch
Standard
®
700D/800DL
®
®
thread from the uppermost
700D/800DL/68