Elasticator Foot - Bernina 700D Owner's Workbook

Hide thumbs Also See for 700D:

Instruction manual (40 pages)

Owner's workbook (140 pages)

User manual (28 pages)

Table of Contents

ASTERING

OUR

BERNINA

• Owner's manual pg.___

• Thread the serger for a 4-thread overlock stitch.

• Set all thread tension levers between 3-5 (normal).

• Adjust stitch length to 4mm.

• Turn the presser foot pressure knob clockwise to increase the pressure.

• Remove the presser foot – Owner's manual page___.

• Following the directions in the Owner's manual for Elasticator, attach the presser foot.

• Locate and raise the roller guide in the front of the presser foot.

• Turn the handwheel to lower the needles. (This also lowers the feed dog.)

• Raise the presser foot and insert the elastic through the slot and under the presser foot until it touches

the needles.

• Lower the presser foot and serge a few stitches to catch and straighten the elastic along the right edge

of the slot. Turn the handwheel to lower the needles.

• Lower the roller guide.

• Using the small screwdriver, adjust the guide plate on the presser foot to the width of the elastic.

• Locate the pressure adjustment set screw (on the top of the roller guide) and turn the screw

counterclockwise to completely loosen the pressure on the roller.

• Place the fabric under the presser foot and begin serging.

• Slowly tighten the pressure adjustment set screw to increase the pressure on the roller and stretch the

elastic. Note: Do not over tighten the screw. Excessive pressure on the elastic will bind the fabric.

• Serge the elastic onto the fabric letting the presser foot stretch the elastic for you.

• Trim and mount the sample.

• Return all settings to normal.

BERNINA

ASTERING

OUR