Kenwood CK 280 Instructions For Use Manual page 20

AUTOMATIC OVEN COOKING
To cook food automatically in the oven,
it is necessary to:
1. Set the length of the cooking time
2. Set the end of the cooking time
3. Set the temperature and the oven
cooking program.
These operations are done in the follow-
ing way:
1. Set the length of the cooking time
required by pushing the
the button to advance, or
back if you have passed the desired
time (fig. 7.5). The AUTO and the
symbol will be on.
2. Set the time you need the food to stop
cooking by pushing the
cooking time already added to the
clock time will appear), and the
button (fig. 7.6); if you pass the
desired time you can go back by
pushing the
After this setting, the
go off. If after this setting, the AUTO
flashes on the panel and a buzzer
goes off, it means there was an error
in the programming, that is the the
cooking cycle has been superimposed
on the clock. In this case, change the
end of cooking time or the cooking
time itself by following the instructions
above.
A
U
T
O
Fig. 7.5
20
button and
to go
button (the
button.
symbol will
3. Set the temperature and the cooking
program (see the relevant sections).
Once the oven is programmed it will
switch on automatically at the right time
to stop the cooking at the desired end
time.
During cooking, the
on.
By pushing the
the time that remains until the end of
cooking.
The cooking program may be can-
celled at any time by pushing
At the end of the cooking time the oven
will turn off automatically, the
will turn off, AUTO will flash and the buz-
zer will sound, which can be turned off
by pushing any of the buttons.
Turn the switch and temperature knobs
to "OFF" and put the programmer onto
"manual" by pressing the
Attention: A powercut will make the
clock go to zero and will cancel the set
programs.
After a powercut, three zeros will flash
on the panel.
A
U
T
O
Fig. 7.6
symbol remains
button you can see
.
symbol
button.