Powering On (Emergency Button); Powering On With Transmit Inhibit (Txi) Active - Motorola CLEARTONE CM5000 Feature User Manual

Hide thumbs Also See for CLEARTONE CM5000:
Table of Contents

Advertisement

Powering On (Emergency Button)

Press and hold the Emergency button to power on.
The CM5000 will power On in Emergency Operation or in
standard mode (as programmed).
The terminal powers On and Off without visible and audible
notification if Silent Emergency Mode is activated.
It is not recommended to use Silent Emergency with a SIM
PIN protected radio as there is no indication to the user when
the PIN number is required.

Powering On with Transmit Inhibit (TXI) Active

Transmit Inhibit is a feature allowing you to switch off
transmission before entering a Radio-Frequency (RF)
sensitive area. To activate this feature, press the Menu
button and select More > Networks > TXI Mode > Activate.
Press the Yes key to deactivate the TXI Mode. If the CM5000
was previously used in Trunked Mode, it will register to the
network. If the CM5000 was previously used in Direct Mode,
it will remain in Direct Mode.
Press No in Trunked Mode and the CM5000 powers down.
Press No in Direct Mode and you remain in Direct Mode with
TXI selected.
If the CM5000 has a SIM card which is PIN protected, you
need to enter the valid PIN or power on the terminal, after
exiting TXI mode.
6
Pressing the Emergency button, even if
Transmit Inhibit is activated, causes the
CM5000 to transmit immediately. The
CM5000 must NOT be within the RF
sensitive area when entering Emergency
Operation.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents